Siemens SINAMICS G110M - Status LED Overview

Alarms, faults and system messages
11.3 Status LED overview
SINAMICS G110M Operating Instructions
294 Operating Instructions, 04/2015, FW V4.7.3, A5E31298649B AD
Parameter
Description
You can change up to 20 different faults into an alarm, or suppress faults:
p2118
Setting the message number for the message type
Selection of the message for which the message type should be changed
p2119
Setting the message type
Setting the message type for the selected fault
1: Fault
2: Alarm
3: No message
You will find details in function diagram 8075 and in the parameter description of the List
Manual.
11.3
Status LED overview
LED status indicators
The Power Module has number of dual-colour LEDs which are designed to indicate the
operational state of the Inverter. The LEDs are used to indicate the status of the following
states:
● General fault conditions
● Communication status
The location of the various LEDs on the Power Module and Communications and Power
Interface (which is attached to the terminal housing) are shown in the figure below.
Figure 11-9 Status LED locations