Siemens SINAMICS G110M - Activating Diagnostics Via the Control; Communication Via PROFIBUS; What Do You Need for Communication Via PROFIBUS

Configure fieldbus
7.3 Communication via PROFIBUS
SINAMICS G110M Operating Instructions
Operating Instructions, 04/2015, FW V4.7.3, A5E31298649B AD
129
7.2.5
Activating diagnostics via the control
The converter provides the functionality to transmit fault and alarm messages (diagnostic
messages) to the higher-level control according to the PROFIdrive error classes.
You must select the functionality in the higher-level control (see Manuals for your converter
(Page 334)) and activate it by booting up.
7.3
Communication via PROFIBUS
7.3.1
What do you need for communication via PROFIBUS?
Check the communication settings using the following table. If you answer "Yes" to the
questions, you have correctly set the communication settings and can control the converter
via the fieldbus.
Questions
Description
Examples
Is the inverter correctly con-
nected to the PROFIBUS?
See Section: Manuals for your converter
(Page 334).
---
Have you configured the com-
munication between the inverter
and the higher-level controller?
See Section: Manuals for your converter
(Page 334)
See Manuals for your
converter (Page 334)
Do the addresses in the inverter
and the higher-level controller
match?
See Section: Settings PROFIBUS DP
address with DIP switches (Page 130).
Is the same telegram set in the
higher-
level controller and in the
inverter?
Adapt the telegram in the inverter. See
Section: Select telegram (Page 131).
Are the signals that the inverter
and the controller exchange via
PROFIBUS correctly intercon-
nected?
Adapt the interconnection of the signals
in the controller to the inverter. For the
PROFIdrive-compliant interconnection in
the inverter, see also Section:
PROFIdrive profile for PROFIBUS and
PROFINET (Page 133).