Siemens SINAMICS G110M - Standards PM240 M

Appendix
A.8 Standards PM240M
SINAMICS G110M Operating Instructions
330 Operating Instructions, 04/2015, FW V4.7.3, A5E31298649B AD
Name
Number
Value
SI forced dormant error detection timer
p9659
<p9659_v>
SI forced checking procedure STO via PM terminals time p9661 <p9661_v>
Table A- 14 Safety logbook
Name
Number
Value
SI checksum to check changes
r9781[0]
<r9781[0]_v>
SI checksum to check changes r9781[1] <r9781[1]_v>
SI change control time stamp
r9782[0]
<r9782[0]_v>
SI change control time stamp
r9782[1]
<r9782[1]_v>
A.8
Standards PM240M
European Low Voltage Directive
The SINAMICS G110M product range complies with the requirements of
the Low Voltage Directive 2006/95/EC. The units are certified for co
m-
plaince with the following standards:
EN
61800-5-1 — Semiconductor inverters –General requirements and line
commutated inverters
EN 60204-1 — Safety of machinery –Electrical equipment of machines
European Machinery Directive
The SINAMICS G110M inverter series does not fall under the scope of the
Machinery Directive. However, the products have been fully evaluated for
compliance with the essential Health & Safety requirements of the directive
when used i
n a typical machine application. A Declaration of Incorporation
is available on request.
European EMC Directive
When installed according to the recommendations described in this manual,
the SINAMICS G110M fulfils all requirements of the EMC Directive as d
e-
fined by the EMC Product Standard for Power Drive Systems EN 61800-3
Underwriters Laboratories
UL and CUL RECOGNIZED POWER CONVERSION EQUIPMENT for use
in a pollution degree 2 environment.
SEMI F47
Specification for Semiconductor Process Equipment Voltage Sag Immunity
SINAMICS G110M Inverters fulfill the requirements
of the SEMI F47-0706
standard.