Siemens SINAMICS G110M - Changes in this Manual

SINAMICS G110M Operating Instructions
Operating Instructions, 04/2015, FW V4.7.3, A5E31298649B AD
5
Changes in this manual
Important changes with respect to the Manual, Edition 04/2014
New Firmware Functions for V4.7.3
In Chapter
New P0015 Macros 33 and 34
p0015 Macros (Page 100)
Updated Inertia Estimator Moment of inertia estimator
(Page 193)
Load torque monitoring
Torque control (Page 199)
Update Energy saving counter Calculating the energy saving
(Page 210)
An overview of all the new and changed functions in the V4.7.3 firmware can be found in
Section New and extended functions (Page 311).
Revised descriptions
In Chapter
Fundamental safety instructions Fundamental safety instructions
(Page 13)
Operational warning and cautions (specifically minimum
cable temperature rating)
Installation (Page 35)
Commissioning tools
Installation (Page 35)
P0015 Macros - new format of diagrams
Basic commissioning (Page 84)
SINAMICS G110M converter SINAMICS G110M converter
(Page 24)
General layout General layout SINAMICS G110M
system (Page 30)
Installing 24 V power supply Installing the 24V power supply
(Page 54)
Electrical information Electrical Installation (Page 57)
Connections and cables
Connection and cables (Page 63)
Wiring examples Figure 4-14 SINAMICS G110M
CU240M ASi terminal diagram
(Page 71)
Adapt inputs and outputs overview
Adapt inputs and outputs (Page 117)
Fieldbus versions of the control modules Fieldbus version of the Control Module
(Page 125)
Communications via AS-i
Communications via AS-i (Page 146)
Overview of converter functions Overview of converter functions
(Page 161)
Inverter control
Inverter control (Page 163)
Setpoint sources
Setpoint sources (Page 169)
Setpoint calculation
.Setpoint calculation (Page 176)
Motor control
Motor control (Page 181)