Siemens SINAMICS G110M - Quick Stop Function

Functions
8.9 Application-specific functions
SINAMICS G110M Operating Instructions
Operating Instructions, 04/2015, FW V4.7.3, A5E31298649B AD
227
Parameter
Description
p1351
Starting frequency, motor holding brake
(factory setting 0%)
Setting the frequency set value at the slip compensation output when starting with
motor holding brake.
When the parameter p1351 is set to > 0, slip compensation is automatically switched
on.
p1352
Starting frequency for motor holding brake
(factory setting 1351)
Setting the signal source for the frequency set value at the slip compensation output
when starting with motor holding brake.
p1475
Speed controller torque set value for motor holding brake
(factory setting 0)
Setting the signal source for the torque set value when starting with motor holding
brake.
8.9.4
Quick Stop function
Overview
The Quick Stop function enables a load on a conveyor system to be detected and if Quick
Stop is enabled, stop the load on the conveyor section.
The load on the conveyor section moves towards a dedicated sensor, as shown in the figure
below.
Figure 8-32 Conveyor example 1
The front edge of the load is detected by the sensor, which initiates the Quick Stop function.
Figure 8-33 Conveyor example 2