Siemens SINAMICS G110M - General Layout SINAMICS G110 M System

Description
3.4 General layout SINAMICS G110M system
SINAMICS G110M Operating Instructions
30 Operating Instructions, 04/2015, FW V4.7.3, A5E31298649B AD
Table 3- 5 Components and tools for commissioning and data backup
Component or tool
Article number
Operator Panel
IOP Handheld Kit - Version 1.5 or later
6SL3255-0AA00-4HA0
Optical cable Required for using IOP Handheld Kit with CU240M 3RK1922-2BP00
STARTER Commissioning tool (PC software) - Version 4.3.3 or later You can obtain STARTER on a DVD
(Order number: 6SL3072-0AA00-0AG0)
and it can be downloaded:
STARTER download
(http://support.automation.siemens.com/
WW/view/en/26233208)
StartDrive Commissioning tool (PC software) - Version 12 or later You can obtain StartDrive on a DVD
(6SL3072-4CA02-1XG0) and it can be
downloaded: StartDrive download
(http://support.automation.siemens.com/
WW/view/en/68034568)
PC Connection Kit Contains the 3 m USB cable necessary to connect your
converter to a PC.
6SL3255-0AA00-2CA0
Optional memory card for storing and
transferring the converter settings
SD card 6SL3054-4AG00-2AA0
3.4
General layout SINAMICS G110M system
Introduction
The locations and description of the various interface connections of the CU240M Terminal
housing (including the Control Module (CM)) and the PM240M Power Module (PM) are
detailed in the figure and table below.
The layout and interfaces of the AS-i variant is shown in a separate figure and table below.
The connections on the terminal housing are delivered with either HAN Q (pluggable) or
Glanded connectors depending on the variant that has been ordered.