Data backup and series commissioning
9.1 Backing up and transferring settings using memory card
SINAMICS G110M Operating Instructions
266 Operating Instructions, 04/2015, FW V4.7.3, A5E31298649B AD
4. Select the settings as shown in the diagram and start the data backup.
5. Wait until STARTER signals that the data backup has been completed.
6. Close the screen forms.
7. Go offline.
8. Switch off the inverter power supply.
9. Wait until all LEDs on the inverter are dark.
10.Switch on the inverter power supply again.
Your settings become effective after switching on.
You have now transferred your settings from a memory card to the inverter.
To Next Page
Loading...
