Data backup and series commissioning
9.4 Write and know how protection
SINAMICS G110M Operating Instructions
276 Operating Instructions, 04/2015, FW V4.7.3, A5E31298649B AD
Factory setting for the exception list:
● p7763 = 1 (selection list contains precisely one parameter)
● p7764[0] = 7766 (parameter number for entering the password)
Note
Block access to the inverter as a result of incomplete exception lists
If you remove p7766 from the exception list, you can no longer enter a password and
therefore no longer deactivate know
-how protection.
In this case to access the inverter again, you have to reset the inverter to the factory
settings.
To Next Page
Loading...
