Siemens SINAMICS G110M - Page 317

Appendix
A.5 Working with STARTER
SINAMICS G110M Operating Instructions
Operating Instructions, 04/2015, FW V4.7.3, A5E31298649B AD
317
Saving settings so that they are not lost when the power fails
The inverter initially only saves changes temporarily. You must do the following so that the
inverter saves your settings securely in the event of a power failure.
Procedure
Proceed as follows to save your settings in the inverter so that they are not lost when the
power fails:
1. Mark the appropriate drive in the project navigator.
2. Click the
Save (RAM to ROM) button.
You have saved your settings securely in the inverter in case of a power failure.
Go offline
You can now exit the online connection after the data backup (RAM to ROM) with
"Disconnect from target system".