Description
3.4 General layout SINAMICS G110M system
SINAMICS G110M Operating Instructions
32 Operating Instructions, 04/2015, FW V4.7.3, A5E31298649B AD
Table 3- 6 Description and location of interfaces
Power Module
Blanking plate - to seal the opposite side of the Terminal
Housing from which the CPI has been fitted.
Interface cover
Cable gland or HANQ connections for left-side mounting
or daisy chaining the mains supply
Communications port 1
Potentiometer
Digital input 2 and digital input 3
Optical I/O connection
Communications port 2
Mini USB connection
Digital output 0 and digital output 1
Memory card reader
Analog input 0 and analog input 1
Braking resistor & motor connection terminals
External 24 Vdc OUT
Communications & Power Interface (CPI) interface ribbon
cable
External 24 Vdc IN
PROFIBUS/USS address and commissioning DIP
switches 1 and 2
Digital input 0 and digital input 1
EM Brake & mains supply connection terminals
Mains supply connection
Control Module (CM)
Terminal housing
PROFIBUS/PROFINET/USS communications cable
To Next Page
Loading...
