6 NC Machine Data (NC MD), NC Setting Data (NC SD) 09.95
6.2 General machine data (general data)
Language switchover
1)
250
Default value Lower input limit Upper input limit Units
001–
Active on
Power On
SINUMERIK 840C can display two languages at option.
The following entries are possible:
0 = Language 1
1 = Language 2
The following language combinations are available:
Language 1 Language 2
German English
German French
German Italian
German Spanish
English French
English Italian
English Spanish
You can check which combination has been ordered and implemented via the ”Control info”
softkey.
M function ”C axis on”
260
Default value Lower input limit Upper input limit Units
- 1 - 1 9 999 - 1
Active on
NC Stop
M function ”C axis off”
261
Default value Lower input limit Upper input limit Units
- 1 - 1 9 999 -
Active on
NC Stop
Active: when all channels of the mode group are in STOP status.
C axis operation is selected and deselected via M functions. The numbers of these M
functions can be allocated on a customer-specific basis.
_______
1) Up to SW 1
6–22 ©
Siemens AG 1992 All Rights Reserved 6FC5197- AA50
SINUMERIK 840C (IA)
To Next Page
Loading...
Need help?
General
