Siemens SITRANS FUG1010 IP65 NEMA 4X - 4.10 THE I;O DATA CONTROL MENU

4-55
1010GCNFM-3C
Section 4
Siemens Dual Path TEST1
Assign Data to Analog Outputs
I/O Data Control
Analog Out Setup
Relay Setup
Analog Input Setup
Use this menu to enable
and span optional
analog inputs.
Use this menu to
assign data functions
to analog outputs.
Use this menu t
o
assign alarm
functions to rela
y
outputs.
To enable the on-screen datalogger display:
1. Press the <Right Arrow> to access the [Display Datalogger] option list.
2. Move the cursor to the desired function.
3. Press <ENT> to invoke the function.
To scroll the on-screen datalogger display:
1. Use the <Down Arrow> to display one line at a time.
2. Use <+> key to scroll down one screen (12 lines) at a time.
3. Use the <=> key to jump to the last screen (12 lines).
In No Line Wrap mode:
Use <Right Arrow>, <Left Arrow>, <ALT + Right Arrow> and <ALT + Left Arrow> to affect lateral screen
movement.
NOTE: The Datalogger uses a compression scheme that precludes backward scrolling.
Important point about Datalogger resources and dual-channel systems
When logging data on both measurement channels simultaneously, please be aware that the
Datalogger stores reports in a single common file. It is important that you select [Site Id] to
appear on each line of data so that you can always identify which channel generated the report.
4.10 THE I/O DATA CONTROL MENU
This menu becomes available after picking a Meter Type and Measurement Channel.
Use this menu to assign functions for the meter’s analog outputs and optional inputs. The [Analog Out
Setup] assigns functions to the meter’s current, voltage and pulse rate outputs. Each menu cell presents
an option list of the available data items. In addition, you can set up the alarm relays, enable and span
the analog input ports.