4-5
1010GCNFM-3C
Section 4
2. Press the <Up or Down Arrows> to scroll the option list to [On], then press <ENT>. [Enter Code?]
appears at the top of the display screen.
3. Use the numeric keys or the <Up or Down Arrows> to move the cursor to the first character position.
4. Press the <Right Arrow> to move the cursor to the second character position.
5. Repeat the selection process for the second character. Continue this process until all the required
characters (8 max.) appear in the field.
6. Press <ENT> to store code. [Confirm Code ?] appears at the top of the display screen.
7. Re-type the code exactly as described above.
8. This moves the cursor to the [Site Security] option list.
9. Use the <Up or Down Arrows> to scroll the option list to [Site Security: On]. Once you turn on Site
Security, you must enter the correct code to turn it off.
10. Press <ENT> to activate Site Security
4.1.5
HOW TO DELETE A SITE SETUP
If you attempt to save a Site Setup when the memory is full, the screen will show [Memory Full]. If you
receive this message after issuing a Save/Rename Site command, then you will have to delete an un-
needed Site Setup to clear memory space. Note that Datalogger storage and Site Storage share a
common memory pool. Therefore, a large amount of logged data could also trigger the [Memory Full]
message. See [Meter Facilities/Datalogger Control] for instructions on how to clear Datalogger memory.
Using the Defragment Command may also allow additional sites to be stored (see Meter Facilities/
Memory Control Menu).
To delete a stored Site Setup:
1. Press the <Down Arrow> to highlight [Delete Site].
2. Press the <Right Arrow> to access the [Delete Site] option list.
3. Move the cursor to the site name of the site setup you want to delete.
4. Press <ENT> to delete the obsolete site setup.
4.1.6
HOW TO SAVE/RENAME A SITE SETUP
The Save/Rename Site command copies data from Active Memory to the Site Storage Memory. Saved
Site Setups can be recalled for future use. This menu cell allows you to save a Site Setup at any time
during the programming process. However, you must recall and complete the Site Setup in order to
achieve operation.
When you access the [Save/Rename Site] menu cell, the name of the most recently created Site Setup
(see Create/Name Site) appears automatically. If this name is acceptable, you can press <ENT> to save
the Site Setup. You may select up to eight characters. If you decide to use numbers or a decimal point in
the site name, you can type these characters directly from the keypad.
To Next Page
Loading...
Need help?
General
