Installation Instructions
CC129A-7
4
z After determining the best sheet cutting pattern from suggestions above, mark the pipe for the
starting edge of the dry couplant sheet position.
z Partially peel the sheet backing 1 to 2 inches from the starting edge, then carefully locate and
press against the pipe surface.
zWhile pressing firmly and sliding your hand against the sheet (along the pipe surface), slowly
peel away the backing such that it prevents the trapping of air.
z Apply the film slowly and carefully so that the sheet does not wrinkle, stretch or overlap,
especially under the transducer contacting surfaces.
z Use the wooden hand roller supplied to smooth the film and assure adhesion to the pipe surface.
zApply additional layers (if required) while avoiding any seams under the transducers.
zUse the wooden hand roller on each layer applied.
z Record final thickness of CC129-1A (from Table 1) for later entry into the 1010GC flowmeter.
CN4973 February 2005
ROLL IN LINE WITH PIPE AXIS
CC129-1A
WOODEN
ROLLER
To Next Page
Loading...
