5. Pry up faceplate and gently lift upwards. Tilt faceplate back and rest it securely so that the
inside of
the flowmeter is accessible but that there is no pressure on the wiring harnesses.
① Faceplate tilted up and back ③ Battery Cover Plate
② Battery Cover Screws (8) ④ Battery Connector P2
Figure 9-2 Battery Cover Removal
6. Remove 8 screws securing the battery cover. Set aside screws.
7. Disconnect pendant battery connector (J2). Note that it is a keyed-type plug.
Maintenance and service
9.2 Replacing the battery
FUP1010 IP67 Portable Flowmeter
Operating Instructions, 02/2010, A5E02951522A Revision 01
113
To Next Page
Loading...
