Appendix
A
A.1 Certificates
All certificates are posted on the Internet. Additionally, the CE Declaration of Conformity as
well as EX approvals are available on the Sitrans F literature CD-ROM Certificates (http://
www.siemens.com/processinstrumentation/certificates)
A.2 Accessories and spare parts
In order to
ensure that the ordering data you are using is not outdated, the latest ordering data
is always available on the Internet: Catalog process instrumentation (
http://www.siemens.com/
processinstrumentation/catalogs)
See also
Process instrumentation catalog (http://www.siemens.com/processinstrumentation/catalogs)
A.3 I/O Connections and Wiring
Terminal Block Wiring - FUP1010 IP67 Battery Powered 2 Channel/2 Path Weatherproof Flowmeter
Wiring
(Refer to manual drawing 1010WDP-7 sheet 2 of 2)
Note
Single Channel flowmeters have the same terminal pin numbers and signals.
The terminal block wiring table applies to the part numbers listed below.
Table A-1 Part Numbers and Connection Data
1010WDP-7 (Sheet 2 of 2) Drawing
FUP1010 7ME3510
Table A-2 2 Channel/2 Path Input/Output Terminal Block Wiring
Pin# Signal Function Description
A GND Signal Ground Return For Signals
B N/C N/C No Connection
C R1B Logic Out 1 Logic Level State (HIGH=5 to 3 Vdc; LOW= 1 to 0 Vdc)
FUP1010 IP67 Portable Flowmeter
Operating Instructions, 02/2010, A5E02951522A Revision 01
137