Siemens SITRANS FUP1010 - Figure 5-27 Track Rail Alignment

3. Use the edge of the Spacer Guide as a stop for both tracks to keep them parallel. Adjust
tracks as necessary.
① Align tracks with Spacer Guide edge
② Mylar Spacer Guide
③ Halfway distance of Spacer Guide
Figure 5-27 Track Rail Alignment
4. Loosen
the
chains
enough to allow you to rotate the track assembly until the center of one
track aligns with the center line on the Spacer Guide and the center of the other track aligns
at the point where the Spacer Guide ends meet. The tracks should now be 180° apart.
Tighten both chains but not too tight.
Connecting
5.2 Sensor Wiring
FUP1010 IP67 Portable Flowmeter
58
Operating Instructions, 02/2010, A5E02951522A Revision 01