To maintain the battery "forming," whenever possible, discharge the battery completely before
recharging. If the operating time during battery use appears to be unusually short, then a
discharge/charge cycle should lengthen the operating time. If this does not correct a short
operating time, then the internal battery should be replaced.
Using the External Battery Pack and Battery Charger (Optional)
The 1015BB (7ME39403BB00) Battery Pack and 1015BCK-2 (USA) (7ME39403BC10) and
1015BCA-2 (EUR) (7ME39403BC20) Power Adapter/Battery Chargers are designed
specifically for use with the portable flowmeters. The 1015BB Battery Pack uses a special
Lead/Acid battery design that features a deep discharge cycle for extended operation.
CAUTION
Do not use any other external Battery Charger/Pack combination with the flowmeter unless
reviewed and pre-approved by Siemens.
CAUTION
Do not leave the Battery Charger connected to the Battery Pack during transportation or
storage. Damage to the Battery/charger connector may occur or the battery may be
discharged.
Connecting
5.1 Transmitter Wiring
FUP1010 IP67 Portable Flowmeter
24
Operating Instructions, 02/2010, A5E02951522A Revision 01
To Next Page
Loading...
Need help?
General
