Siemens SITRANS FUP1010 - Page 71

Level A Level B Level C Level D Level E Level F Level G Level H
Full Site
Setup
Channel
Setup
Recall Site Enter From List
Channel Enable Enter From List
Create/Name Site Enter From List
Site Security On/Off
Delete Site Enter/Clear Site
Name
Save/Rename
Site
Enter From List
Pipe Data Pick Pipe Class Enter From List
Select Pipe Size Enter From List
Pipe OD (in) Numeric Entry
Pipe Material Enter From List
Wall Thickness Numeric Entry
Liner Material Enter From List
Liner Thickness Numeric Entry
Application
Data
Liquid Class Select Liquid Enter From
List
Estimated Vs MS Numeric
Entry
Viscosity (cS) Numeric
Entry
Density S.G. Numeric
Entry
Temp. Range Enter From List
Pipe Config Enter From List
Anomaly Diams Numeric Entry
Install Xdcr Transducer Model Enter From List
Transducer Size Enter From List
Xdcr Mount Mode Enter From List
Spacing Offset Enter From List
Number Index View Only
Spacing Method View Only
Ltn Value (in) View Only
Install Complete No / Install Select
Install
Empty Pipe Set Enter From List
Zero Flow Adjust Enter From List
Operation
Adjust
Damping Control Time Average /
SmartSlew
Deadband
Control
Numeric Entry
Memory/Fault Set Fault/Memory
Memory Delay (s) N/A
Commissioning
6.4 Installation Menus
FUP1010 IP67 Portable Flowmeter
Operating Instructions, 02/2010, A5E02951522A Revision 01
69