Setting the Analog Current Input
The DC current input port must be enabled first. From the [Analog Inp Setup] menu proceed
as follows:
1. Access the [Iin1] option list by pressing the <Right Arrow> twice.
2. Move
the cursor down to [Aux] by pressing the <Down Arrow> and then press <ENT>. This
enables the port to receive an input current. The cursor moves to [4 mA].
Functions
7.8 Analog Input Setup
FUP1010 IP67 Portable Flowmeter
90
Operating Instructions, 02/2010, A5E02951522A Revision 01
To Next Page
Loading...
