Smartrise F220

213
 VIEW MEMORY
 This is a troubleshooting parameter that is reserved for factory setup. Do not change unless directed
by Smartrise.
 ADJUST PARAMETERS
 These are troubleshooting parameters that are reserved for factory direction. Do not change unless
directed by Smartrise.
 BINARY PARAMETERS
 These are parameters that can be changed by the installer to adjust operation. Refer to Addendum V
for a complete list of parameters currently available.
 COMM STATUS
 This is a troubleshooting parameter that is reserved for factory direction. Do not change unless
directed by Smartrise.
 PASSCODE
 The 5-digit password required to enable Normal Operation. The passcode can be obtained from the
Smartrise Accounting Dept.
 MAIN MENU | SETUP | ABOUT |
 Describes the controller board, job name and software version the controller is using.