264
Step 2 - Installing the Smartrise Programmer
Special considerations need to be made when installing the software:
Do you have the Smartrise Programmer Application to install the software?
- If not, install the application by doing the following:
1. Open the (5) New Smartrise Programmer Folder in your software package
2. Open the 1 – Programmer Installer Folder
3. Install the Smartrise Programmer
4. Once the Smartrise Programmer is installed go back to the index of folders (shown below)
and open the:
(1) Controller Software folder with the JCF Software file inside shown below:
5. Open the Software Folder, in this example the version is 2.20h, the version will vary on
how recent the job is.
6. Open the JCF file by double clicking on it. If it doesn’t open then the Smartrise
Programmer might not be correctly installed. Please see previous page for installation
instructions.
To Next Page
Loading...