Smartrise F220

48
Operation
(Check off box when complete)
Run the car and verify the following:
No Faults
 Make sure the car is moving without triggering a fault either on
the Smartrise SRU or the drive. If the SRU board displays a “Drive
Fault” on the SRU, look at the drive to see what the fault is. The
most common fault is “Encoder Flt”.
o Go to “Troubleshooting – Drive Fault / Encoder Flt” for
corrective actions.
Proper Direction
 Make sure the car is moving in the same direction as the control
switch on the Run Bug.
o Go to “Troubleshooting – Wrong Direction” for corrective
actions.
At Speed
 Make sure that the car is moving at the proper inspection speed
(approx. 50 FPM).
o Go to “Troubleshooting – Car Moving Too Slow or Rough”
for corrective actions.
Under Control
 Make sure that the car is moving under full control. The car
should stop when commanded from the Run Bug. Verify that the
car runs with no faults for 10 seconds or more.
o Go to “Troubleshooting – Brake Not Lifting” for corrective
actions.