65
EQUIPMENT/SETTINGS VERIFICATION
Verify that the Job Specification parameter table on the drawings
“Sheet 1: Getting Started” matches the actual equipment.
Below is a sample table showing the important values that will
affect operation.
STATIONARY PM AUTO TUNING
The auto tune function must be performed for a PM motor to
properly operate. The three “Auto Tunes” required are: Motor
Tuning, 1
st
Phase of Encoder Tuning and 2
nd
Phase of Encoder Tuning.
** During the alignment process the Smartrise SRU board will display
several faults. These are normal and won’t affect the alignment
procedure. **
Sample: Sheet 1: - Getting Started
To Next Page
Loading...