SH/1250/3 12-1
12
Recording, Learning and Storing
Facilities
Section Page
12.1 The Data Output Key 12.2
12.1.1 Introduction 12.2
12.1.2 [DATA OUTPUT] 12.2
12.1.3 [FORMAT]: Heading and Reformat 12.3
12.1.4 Heading 12.3
12.1.5 Reformat 12.4
12.1.6 Menu Changes Activating the Heading and Reformat Functions 12.5
12.1.7 Channel and Range Column Conventions 12.5
12.1.8 [GPIB CONFIGURE] 12.6
12.1.9 Parallel and Poll Sense 12.6
12.1.10 Serial Poll 12.6
12.1.11 Terminator and Separator 12.6
12.2 The File 12.7
12.2.1 Introduction 12.7
12.2.2 Maximum File Size 12.7
12.2.3 Selecting File Size 12.7
12.2.4 Overwriting the Size of the File 12.7
12.2.5 Starting a File 12.8
12.2.6 Reading from the File 12.8
12.3 Learnt Programs 12.9
12.3.1 Introduction 12.9
12.3.2 Learning a Program: From the Front Panel 12.9
12.3.3 Learning a Program: From an External Device 12.10
12.3.4 Executing a Program 12.11
12.3.5 Editing a Program: From the Front Panel 12.11
12.3.6 Editing a Program: From an External Device 12.12
12.3.7 Copying a Program 12.12
12.3.8 Program Pause/Continue Key 12.13
12.3.9 Example Programs 12.13
12.3.10 Error Messages Displayed During Program Running 12.13
12.4 X - Y Plotter 12.14
12.4.1 Introduction 12.14
12.4.2 Setting up a Plot: Non-Plotter Menus 12.14
12.4.3 The [PLOTTER COMMON] menu 12.15
12.4.4 The [PLOTTER X-AXIS] and [PLOTTER Y-AXIS] menus 12.16
12.4.5 The [PLOTTER SCALING] menu 12.17
12.4.6 Performing a Plot 12.18
12.4.7 Bode and Nyquist Plots 12.19
12.4.8 Adjusting the Plotting Field to suit Preprinted Chart Paper 12.20
12.4.9 Pen Selection with two Pen Plotters 12.21
12.4.10 Plotting Data from the File 12.21
To Next Page
Loading...
