Additional Displayed Information 1250 Frequency Response Analyzer
11-4 AMK/1250/3
MAIN STATUS (cont.)
Soft Key Page Display
SWEEP 1 SWEEP STOP/IDLE/HOLD/RUN TYPE harm up/lin/up/
lin down/log up/log down
2 F. MIN (Hz) F. MAX (Hz) *
value value value
* For LOG: st/dec or st/oct or st/swp or ratio
For LIN: st/swp or step (Hz)
where st = step, dec = decade, oct = octave, swp = sweep.
For HARMONIC there is no entry.
DISPLAY 1 DISPLAY Ch01 to 48 or Ch n/m IN a,b / r,theta / log r,theta
RANGE value *
* e.g. 3V. This figure shows the range used in the last completed
measurement, even where the Analyzer is on Auto-Range. If a ratio
measurement was made, both ranges will be shown e.g. 3V/30mV.
PLOTTER 1 PLOTTER STOP/IDLE/RUN/NONE X-Ch *
A3/A4 point/vector Y-Ch
* The Channel number will be given as for DISPLAY, followed by
a/b/r/theta deg/theta rad/log r dB/ƒ Hz/logƒ Hz.
2 X-MIN X-MAX X-ORIGIN
value value value
3 Y-MIN Y-MAX Y-ORIGIN
value value value
To Next Page
Loading...
