Recording, Learning and Storing Facilities 1250 Frequency Response Analyzer
12-6 SH/1250/3
12.1.8 [GPIB CONFIGURE]
This page of the DATA OUTPUT menu accesses five soft keys, concerned with the
remote control of the 1250. The soft keys and selections are as follows:
PAR. POL P. SENSE SER. POL TERM. SEP.
(0) [ true ] (0) [ cr lf ] [ comma ]
[ false ] [ cr lf + EOI ] [terminator]
[ cr ]
[ cr + EOI ]
Chapter 13 gives details of the use of these functions for remote control; the following
sections are a summary.
12.1.9 PARALLEL POLL AND POLL SENSE
Pressing the 'PAR. POL' soft key produces the display:
PAR. POL (0)
An integer from 1 to 8 is input (between the round brackets) to define which of the eight
GPIB data lines is to be used by the 1250 to give a Parallel Poll response, indicating
whether it is requesting service or not.
The 'P. SENSE' (POLL SENSE) soft key can be set up as [true] or [false] using the
SELECT key; [true] is the default state.
Chapter 13, Section 13.2, explains the significance of these selections.
12.1.10 SERIAL POLL
Pressing the 'SER. POL' soft key produces the display:
SER. POL ( 0)
An integer from 1 to 255 is input, which configures the 1250 to interrupt the GPIB
Controller when a particular event occurs. This is explained in detail in Chapter 13,
Section 13.1.
12.1.11 TERMINATOR AND SEPARATOR
The 'TERM.' and 'SEP.' soft keys are used to select the Output Terminator character
(terminating each line of data), and the Output Separator character (separating the line
into fields), respectively.
The default characters generated by the 1250 are 'cr If' as Terminator, and 'comma' as
Separator. If [terminator] is selected for the Separator, this sets the Separator character
to be the same as the Terminator.
Chapter 13, Section 12.6 gives further details.
To Next Page
Loading...
