Solartron 1250 - Page 11

Contents 1250 Frequency Response Analyzer
6 1250
14.4 Power Fail 14.5
Chapter 15 Options
15.1 Synchroniser Unit 12501 15.2
15.1.1 Introduction 15.2
15.1.2 Description 15.2
15.1.3 Installation 15.2
15.1.4 Connecting Up 15.2
15.1.5 Modes of Operation 15.3
15.1.6 The Synchroniser Menu 15.5
15.1.7 Procedure for Establishing the Sync. Locked State 15.8
15.1.8 Synchroniser Status 15.9
15.1.9 Measuring Harmonics: Use of Order Analysis 15.11
15.2 Modulator/Demodulator Unit 12502 15.12
15.2.1 Introduction 15.12
15.2.2 Installation 15.12
15.2.3 Connections 15.12
15.2.4 Setting Up 15.12
15.3 Analog Plotter Interface 12503 15.13
15.2.1 Introduction 15.13
15.2.2 Installation 15.13
15.2.3 Preset Controls 15.14
15.2.4 Setting Up and Performing a Plot 15.14
15.4 Auxiliary generator Unit 12505 15.15
15.4.1 Introduction 15.15
15.4.2 Description 15.15
15.4.3 Installation 15.15
15.4.4 Setting Up 15.16
Chapter 16 The 1251 Multichannel Analyzer System
16.1 Introduction 16.2
16.2 Description 16.2
16.3 System Configuration 16.2
16.3.1 1250-1251 Interface Bus 16.2
16.3.2 IEEE 488 Interface Bus 16.2
16.3.3 1250 Series Options 16.2
16.4 Connecting Up 16.4
16.4.1 Safety: Connecting the ac Mains 16.4
16.4.2 Connecting up the 1250-1251 Interface Bus 16.4
16.5 1251 Unit Identification Switches 16.5
16.5.1 Analyzer Channel Numbering 16.5
16.6 Manual Operation of the System 16.5
16.6.1 Introduction 16.5
16.6.2 Manual Setting up of the 1251 System 16.5
16.6.3 Setting up the 1251 Analyzers 16.6
16.6.4 Displaying and Plotting data from the 1251 Analyzers 16.6
16.6.5 Checking the Analyzer and Display/Plotter Menu Settings 16.7
16.7 Remote Operation of the System 16.7
16.7.1 Introduction 16.7
16.7.2 GPIB Capability Code 16.7
16.7.3 Setting up the GPIB Configure Menu 16.8
16.7.4 Data Transfer Speeds 16.8
16.7.5 GPIB Output Buffers 16.8
16.7.6 GPIB Addresses 16.9
16.7.7 1251 Multichannel Analyzer Output: Complete Block Format 16.9
16.7.8 ASII Format 16.9