The RS423 and GPIB Ports. Remote Control 1250 Frequency Response Analyzer
13-2 AMK/1250/4
13.10 Measurement Output Selection 13.20
13.10.1 Via RS423 Port 13.20
13.10.2 Via GPIB Interface 13.20
13.11 Measurement Output Rate 13.21
13.11.1 Via RS423 Port 13.21
13.11.2 Via GPIB Interface 13.21
13.12 Measurement Output Format 13.21
13.12.1 RS423 Port 13.21
13.12.2 GPIB Talk Only Mode 13.21
13.12.3 GPIB Normal Mode 13.22
13.12.4 Dump Mode 13.23
13.12.5 Floating Point Format 13.23
13.12.6 Output Terminators and Separators 13.24
13.13 Serial Poll/Parallel Poll 13.25
13.13.1 Serial Poll 13.25
13.13.2 Parallel Poll 13.26
13.14 Learnt Programs. External Storing and Reloading 13.27
13.14.1 RS423 Port, Device Control Characters 13.27
13.14.2 Procedure for Storing a Learnt Program Externally, Via RS423 Port 13.28
13.14.3 Procedure of Loading a Learnt Program into the 1250,
Via RS423 Port 13.28
13.14.4 Procedure of Loading a Learnt Program into the 1250,
Via GPIB Port 13.28
13.14.5 Example of Controller Program for Transferring Learnt program 1
from 1250 via GPIB Port, Without Handshake 13.29
13.14.6 Example of Controller Program for Transferring Learnt program 1
from 1250 via GPIB Port, With Handshake 13.29
13.14.7 Reloading a Learnt Program to 1250 Via GPIB 13.29
13.15 File Output 13.30
13.15.1 Procedure to Output the File Via RS423 Port by External Command13.30
13.15.2 Procedure to Output the File Via GPIB Port 13.30
13.15.3 Example of Controller program for Copying the File to the GPIB
Without Handshake 13.31
13.15.4 Example of Controller program for Copying the File to the GPIB
With Handshake 13.31
13.16 GPIB Plotting 13.31
13.16.1 Operating Sequence for GPIB Plotter, Using a Controller 13.32
13.17 Combinations of RS423 and GPIB Devices 13.32
To Next Page
