Solartron 1250 - Page 193

Plotter X-Axis and Plotter Y-Axis Menus............................................. 12.16
Plotting............................................................................................... 12.18
Plotting Data from the File.................................................................. 12.21
Plotting Field Adjusting to suit Preprinted Chart Paper ....................... 12.20
Power Fail ......................................................................................... 14.5
Program Commands.......................................................................... 13.14
Program Pause/ Continue Key........................................................... 12.13
Program, Editing from an External Device......................................... 12.12
Program, Editing from the Front Panel .............................................. 12.12
Program, Executing............................................................................ 12.11
Program, Learning from an External Device....................................... 12.10
Program, Learning from the Front Panel............................................. 12.9
Programs, Learnt................................................................................ 12.9
REMOTE/LOCAL facility..................................................................... 13.6
RS423 Baud Rate............................................................................... 13.4
RS423 Input Command Terminator Character..................................... 13.4
RS423 Port, Character Device Control/s.............................................. 13.27
RS423 and GPIB Devices, combinations............................................. 13.32
RS423/GPIB Commands..................................................................... 13.14
Rack Dimensions................................................................................. 2.5
Rack Mounting..................................................................................... 2.4
Range.................................................................................................. 5.6
Reformat............................................................................................. 12.4
Reloading a Learnt Program to 1250 via GPIB.................................... 13.29
Resetting............................................................................................. 3.4
Safety Precautions: Installation........................................................... 2.2
Scaling................................................................................................ 10.5
Self Test.............................................................................................. 14.2
Self Test Commands........................................................................... 13.16
Serial Poll............................................................................................ 12.6
Serial Poll/Parallel Poll........................................................................ 13.25
Sources............................................................................................... 7.3
Status Commands............................................................................... 13.13
Status Display: Generator.................................................................... 4.4
Status Key........................................................................................... 11.2
Status Main.......................................................................................... 11.3
Status Other......................................................................................... 11.5
Status: Printed Record......................................................................... 11.8
Stop @ Key, Application...................................................................... 4.6
Storing a Learnt Program Externally,
via RS423 Port............................................................................... 13.28
Supervisor, Keyswitch position............................................................ 1.6
Supervisor, memory for Learnt Programs............................................ 12.9
Sweep Commands.............................................................................. 13.12