Installation 1250 Frequency Response Analyzer
2-12 CWB / 1250_Op / Issue 9A
c. Side Trim
Located on the opposite side to the handle, it is normally secured by a pip on the
finisher trim, and slides out backwards.
Check that the threaded bar supplied already fitted behind the side trim is part
no. 12502019B.
d. Case Top and Case Bottom
Retain the five screws and washers for securing the replacement cases.
2. Fit the Self-adhesive Feet (4 off) to the inside of the Replacement Case Bottom in
the positions corresponding to those in the original case bottom.
3. Fit the following items to the unit, as shown in Fig. 2.10 overleaf:
a. Rack Ears (2 off)
Fit the rack ears in place of the finisher trim, using the same fixings. The flanges
must face the rear of the 1250.
b. Slide Mounting Bar
Screw the bar to the chassis in the former position of the handle, using the four
M4x12 countersunk screws provided. The bar fits correctly only one way round,
with the threaded holes nearest the front.
c. Replacement Case Top and Case Bottom
Use the original five screws and washers.
Fit the Jonathan Telescopic Slide (not supplied), e.g. Tru-Glide 110QD-2, and mounting
brackets to the unit and fit it into the rack. See the Manufacturer's slide specification
sheets for details of the fixings, brackets and mounting accessories.
To Next Page
Loading...
