1250 Frequency Response Analyzer
1250
SAFETY PRECAUTIONS (continued from previous page)
SAFETY SYMBOLS
For the guidance and protection of the user, the following safety symbols appear on the
equipment:
SYMBOL MEANING
Refer to operating manual for detailed instructions of use. In
particular, note the maximum voltages permissible at the input
sockets, as detailed in the Specification.
Hazardous voltages.
NOTES, CAUTIONS AND WARNINGS
For the guidance and protection of the user, Notes, Cautions and Warnings appear
throughout the manual. The significance of these is as follows:
NOTES highlight important information for the reader’s special attention.
CAUTIONS guide the reader in avoiding damage to the equipment.
WARNINGS guide the reader in avoiding a hazard that could cause injury or death.
AVOID UNSAFE EQUIPMENT
The equipment may be unsafe if any of the following statements apply:
• Equipment shows visible damage.
• Equipment has failed to perform an intended operation.
• Equipment has been subjected to prolonged storage under unfavorable conditions.
• Equipment has been subjected to severe physical stress.
If in any doubt as to the serviceability of the equipment, don’t use it. Get it properly checked
out by a qualified service technician.
LIVE CONDUCTORS
When the equipment is connected to its measurement inputs or supply, the opening of
covers or removal of parts could expose live conductors. The equipment must be
disconnected from all power and signal sources before it is opened for any adjustment,
replacement, maintenance or repair. Adjustments, maintenance or repair, must be done
only by qualified personnel, who should refer to the Maintenance Manual.
EQUIPMENT MODIFICATION
To avoid introducing safety hazards, never install non-standard parts in the equipment, or
make any unauthorized modification. To maintain safety, always return the equipment to
Solartron for service and repair.
To Next Page
Loading...
