Solartron 1250 - Chapter 6 The Sweep Facility

6-1 CHFR/1250/2
6
The Sweep Facility
Section Page
6.1 Introduction 6.2
6.2 Logarithmic Sweep 6.2
6.3 Linear Sweep 6.2
6.4 Setting Up a Logarithmic or Linear Sweep 6.3
6.5 Executing the Sweep 6.3
6.6 Automatic Sweep Time 6.3
6.7 End of Sweep Conditions 6.4
6.8 Further Sweeps 6.4
6.9 Stopping and Re-starting the Sweep 6.4
6.9.1 Introduction 6.4
6.9.2 Commands Which Produce “Sweep Stop” Status 6.4
6.9.3 Commands Which Produce “Sweep Idle” or “Hold” Status 6.5
6.10 Changing Parameters in Mid-Sweep 6.5
6.11 Harmonic Sweep 6.5
6.11.1 Introduction 6.5
6.11.2 Perfoming a harmonic Sweep 6.6
6.11.3 Error 21 6.6
6.11.4 Sweep Termination Conditions 6.6