Solartron 1250 - Page 7

Contents 1250 Frequency Response Analyzer
2 1250
4.5.3 Generator Stop @ Key 4.6
4.5.4 Applications of the Stop @ Key 4.6
4.5.5 Generator Overload Protection 4.7
Chapter 5 Making Measurements: The Analyzers
5.1 Introduction 5.2
5.2 Setting the [ANALYZER COMMON] Menu 5.2
5.2.1 ∫ Time 5.2
5.2.2 Delay 5.3
5.2.3 Harmonic 5.3
5.2.4 Order 5.4
5.2.5 Auto ∫ 5.4
5.2.6 Application of Auto Integration 5.4
5.3 Setting Individual Analyzers 5.6
5.3.1 Range 5.6
5.3.2 Demod 5.6
5.3.3 Coupling 5.6
5.3.4 Input 5.6
5.4 Measurement Start 5.7
5.5 Stopping the Analyzer; Stop and Break Keys 5.8
5.6 Changing Menus during Recycle 5.8
5.7 Measurement Start Point 5.8
5.7.1 Implementation of Delay 5.8
Chapter 6 The Sweep Facility
6.1 Introduction 6.2
6.2 Logarithmic Sweep 6.2
6.3 Linear Sweep 6.2
6.4 Setting Up a Logarithmic or Linear Sweep 6.3
6.5 Executing the Sweep 6.3
6.6 Automatic Sweep Time 6.3
6.7 End of Sweep Conditions 6.4
6.8 Further Sweeps 6.4
6.9 Stopping and Re-staring the Sweep 6.4
6.9.1 Introduction 6.4
6.9.2 Commands Which Produce “Sweep Stop” Status 6.4
6.9.3 Commands Which Produce “Sweep Idle” or “Hold” Status 6.5
6.10 Changing Parameters in Mid-Sweep 6.5
6.11 Harmonic Sweep 6.5
6.11.1 Introduction 6.5
6.11.2 Perfoming a harmonic Sweep 6.6
6.11.3 Error 21 6.6
6.11.4 Sweep Termination Conditions 6.6
Chapter 7 The Display Menu and Mini Status
7.1 Introduction 7.2
7.2 Sources 7.3
7.3 Co-Ordinates 7.3
Chapter 8 Menu Summary
8.1 Introduction 8.2
Chapter 9 Additional Generator Controls
9.1 The Variable Key 9.2
9.1.1 Introduction 9.2