Solartron 1250 - Page 9

Contents 1250 Frequency Response Analyzer
4 1250
12.1.11 Terminator and Separator 12.6
12.2 The File 12.7
12.2.1 Introduction 12.7
12.2.2 Maximum File Size 12.7
12.2.3 Selecting File Size 12.7
12.2.4 Overwriting the Size of the File 12.7
12.2.5 Starting a File 12.8
12.2.6 Reading from the File 12.8
12.3 Learnt Programs 12.9
12.3.1 Introduction 12.9
12.3.2 Learning a Program: From the Front Panel 12.9
12.3.3 Learning a Program: From an External Device 12.10
12.3.4 Executing a Program 12.11
12.3.5 Editing a Program: From the Front Panel 12.11
12.3.6 Editing a Program: From an External Device 12.12
12.3.7 Copying a Program 12.12
12.3.8 Program Pause/Continue Key 12.13
12.3.9 Example Programs 12.13
12.3.10 Error Messages Displayed During Program Running 12.13
12.4 X - Y Plotter 12.14
12.4.1 Introduction 12.14
12.4.2 Setting up a Plot: Non-Plotter Menus 12.14
12.4.3 The [PLOTTER COMMON] menu 12.15
12.4.4 The [PLOTTER X-AXIS] and [PLOTTER Y-AXIS] menus 12.16
12.4.5 The [PLOTTER SCALING] menu 12.17
12.4.6 Performing a Plot 12.18
12.4.7 Bode and Nyquist Plots 12.19
12.4.8 Adjusting the Plotting Field to suit Preprinyed Chart Paper 12.20
12.4.9 Pen Selection with two Pen Plotters 12.21
12.4.10 Plotting Data from the File 12.21
Chapter 13 The RS423 and GPIB Ports. Remote Control
13.1 Introduction 13.3
13.1.1 GPIB Capacity Code 13.3
13.2 Connections 13.4
13.3 RS423 Baud Rate 13.4
13.4 RS423 Input Command Terminator Character; RS423 Character
Frame 13.4
13.5 GPIB Switches 13.5
13.5.1 Address switches 13.6
13.5.2 Input Command Terminator Character Switches 13.6
13.5.3 Talk Only Switch 13.6
13.5.4 GPIB Switch Example 13.6
13.6 REMOTE/LOCAL Facility 13.7
13.6.1 Local Lock-Out 13.8
13.7 Command Codes 13.9
13.7.1 Introduction 13.9
13.7.2 Command Code Format 13.9
13.7.3 Generator Commands 13.10
13.7.4 Synchroniser Commands 13.10
13.7.5 Amplitude Compression Commands 13.11
13.7.6 Auxiliary Generator Commands 13.11
13.7.7 Analyzer Commands 13.11
13.7.8 Sweep Commands 13.12
13.7.9 Display Commands 13.12