1250 Frequency Response Analyzer Additional Displayed Information
AMK/1250/3 11-7
µµP (cont.)
Page Display
3 LAST UPPER LOWER
LIMIT value value
This page can be used to determine the limits which apply to the current
parameter being entered, as an alternative to looking it up in the full
specification. For example, if the maximum Generator output voltage is
not known, enter an arbitrary value in the Generator menu. This can be
either a known permissible value, e.g. 1 Volt, or an excessive value
such as 90 Volts. Now call up page 3 of the microprocessor status, and
the available limits for the Generator output voltage will he displayed.
4 DATA GPIB RS423 DISPLAY FILE
O/P off/ off/ off/ off/
all/ all/ all/ all/
fail/ fail/ fail/ fail/
pass/ pass/ pass/ pass/
dump dump
Note: see Chapter 12, DATA OUTPUT key, Section 1.2 for explanation
of above messages.
5 REFORMAT HEADING
on/off on/off
Note: see Chapter 12, DATA OUTPUT key, Section 1.3 for explanation
of above messages.
GPIB 1 GPIB MODE STATE ADDRESS
t.only/ IDLE/ e.g. 00/10
normal maj TACS/
min TACS/
maj LACS/
min LACS
Notes: where t. = talk, normal = bi directional, maj = major, min = minor
TACS =Talker Active State LACS = Listener Active State
The pair of numbers appearing under "ADDRESS" are the major and
minor addresses respectively, as explained in Chapter 13, section 5.1.
To Next Page
Loading...
