Plug-In Display Modes
There are three display modes, Insert, Parameter and Assign, which are selected with the ASSIGN and
I
NSERT/PARAM buttons below the V-pots.
Viewing Current Inserts (Insert Mode)
P
ress the INSERT/PARAM button till the INSERT/PARAM box reads INSERT; the plug-in editor is in Insert
mode. In this mode the four V-pots represent four insert points on the selected channel. The currently assigned plug-ins
a
re displayed above each V-pot. The name of the currently active plug-in will flash.
Additional insert points can be displayed using the paging buttons.
The four V-pot push switches can be used to select an insert slot for editing or for plug-in assignment - see below.
Assigning a Plug-In or Hardware I/O (Insert Mode)
Note: Some DAW applications will not allow assignments to be made during playback, or recording.
To Assign a Plug-in to a Channel Insert Point:
1. Press the ASSIGN soft button to enter assign mode; the on-screen box flashes to confirm this.
2. Press the V-pot corresponding to the insert slot which you wish to route to a plug-in (use the paging buttons if
necessary) then use the V-pot to scroll through a list of plug-ins and I/O slots. The names that are displayed are derived
from the DAW.
3. To confirm the assignment either:
a. Press the ASSIGN button a second time. This will exit INSERT mode and switch the Plug-In
Editor to PARAMETER mode for editing of the last selected insert.
b. Press the V-pot used to make the assignment. This will confirm the assignment and leave you in
Assign mode so you can make further assignments.
Assigning the Same Plug-in to All Channels
Follow steps 1 and 2 above to select a plug-in, then hold down the OPTION button before pressing the V-pot switch to
assign a plug-in to all channels.
Assigning The Same Plug-in to Selected Channels
To assign a plug-in to selected channels select SEL mode on the Master Control Panel then choose the channels you wish
to assign to by holding down SHIFT and pressing the channel SEL keys.
Follow steps 1 and 2 above to select a plug-in, then hold down OPTION+ SHIFT before pressing the V-pot switch to
assign the plug-in to the selected channels.
DAW Control
Page 4-22 AWS 924-948 Owner’s Manual
To Next Page
Loading...
Need help?
General
