Page 7-8 AWS 924-948 Operator’s Manual
Automation
JOIN AND REVISE
At any time during Mix Review, the Join key can be used to switch all channels originally in write at the last rollback point
back to write at the levels or state they were at the rollback point. This is useful, for example, when balancing a chorus level.
When you have achieved this balance, you can rollback, hit Join and the levels will punch in at the balance set before rollback,
and all channels immediately return to write.The Revise key has a similar action except that all channels in write at the
Rollback point are returned to write at their current mix position. This is useful if you have been automating a section, but
m
ade a small mistake. Just rollback prior to the mistake, hit Revise and the channels will immediately go into write at the
current fader level, allowing you to overwrite the mistake.
Multiple Rollback memories are supported so that successive operations of Join or Revise return different sets of faders back
to the write state, if multiple Rollback operations have taken place.
To return all faders to Absolute,
press the Join or Revise keys until
the Global Rollback memory is
reached, at which point all
faders return to write either at
the current position, via the
Revise function, or at the
balance at the Global Rollback
point, via the Join function.
Discard
If the system is in play or stopped following a Rollback operation with any faders or cuts in Absolute mode, Discard clears
any data made since the start of the Rollback pass and forces all channels in Absolute back to Replay. The Discard label
is only shown when there is Mix data to discard.
Updating a Mix Pass
To update a Mix Pass, select the desired Mix Pass from the list on the List Mix menu by turning the left V-pot and press
the V-pot switch. ‘Updating Mix Pass’ will be displayed and the selected mix will now be the reference mix.
To Next Page
Loading...
Need help?
General
