WORKING WITH PROJECTS AND TITLES
At least one Project and Title must be present before you can store an automated Mix. Select SSL followed by Proj. Now
s
elect New Proj and the system will create a new Project and Title; logically these will be named Project 1 and Title 1 (if
no previous projects exist).
If Projects have been previously created, when you press the Proj key, the screen will display a list of existing Projects. Use
the left-hand encoder to scroll through the list and when you find the Project you require, press the encoder switch (or
soft key below the encoder) that represents the Select function. This makes that Project current (as indicated by the entry
being highlighted in yellow, with the word selected after its name) and reveals the Titles in that Project. To create a new
Title in a Project, select New Title. Titles and Projects are automatically numbered in sequence of creation. Select Copy
Title to copy the selected Title.
Note that the top line of the display always indicates the current Project and current Title. Use the Select rotary control
to scroll through lists of Projects, Titles, etc., and the encoder switch to select them. To return at any time to the Project
list, press the Back softkey.
AWS 948 TRANSFER COMPATABILITY
Note that when loading Titles created on a 900 or 924 onto a 948, the automation is applied to both sides of a stereo
channel. In In-Line modes, automation is applied to the primary channel path, and the secondary channel path drops into
Manual.
Setup Guide: Console Config
Page 7-2 AWS 924-948 Operator’s Manual
To Next Page
Loading...
Need help?
General
