Panning, Width and Balance
The pan pot towards the bottom of the channel strip is used to adjust the stereo position of signals being sent to the
R
ecord and Mix busses, as well as to the Track busses when they are functioning in stereo.
Level, Cuts and Solos
T
he channel fader controls the channel send to the Rec and Mix busses, as well as any other sends which are operating post-
fader. Use the CUT and SOLO switches below the digital display to mute or solo the signal assigned to the fader.
AWS 924 Tutorial
Page 2a-4 AWS 924-948 Owner’s Manual
To Next Page
Loading...
Need help?
General
