HUI AUTOMATION
The AWS’s touch sensitive moving faders can be used to write automation for the DAW fader. Most automation functions
can be enabled from the soft key matrix below the console’s display screen. Within this are menus for Automation Enables,
Automation Modes, Grouping and Editing functions.
A-FADA, which uses DAW automation to control analogue faders, is descibed on Page 4-7.
N
ote: Automation data can usually only be written when the DAW is in Play, Half-Speed Play or Record.
Automation Enables
Automation Enable modes (AuEn) globally engage or disengage automation for the following items: Faders, Pans, Plug-Ins,
Cuts (Mute), Sends and Send Muting (SnMute). Holding down the OPTION button then pressing any of the sub menu
buttons will toggle automation on or off for all controls.
The Pan automation enable includes both Channel and Send Pan.
Automation Modes
There are several Automation Modes (AuMo) available including: Write, Touch, Latch, Trim, Read and Off.
To change automation mode on a channel select an automation mode from the soft key menu and press the auto button
on a channel fader. Holding down OPTION then selecting an automation mode from below the TFT screen will change
automation modes on all channels. Changes within the DAW will be reflected on the console.
Refer to your DAW manual for more information on its specific automation features.
Automation Status Display
Pressing and holding the auto button to the left of a channel fader will display the current
automation mode for that channel in the channel scribble strip display. To display the automation
mode on all channels select the Status Group (StGr) soft menu, and press Auto.
The automation LED indications are as follows:
No LED Automation off
Green LED Read automation mode
Red Flashing LED DAW is ready to write automation in write, touch or latch modes.
Red solid LED Writing automation data
Red and Green LEDs Trim automation mode
DAW Control
AWS 924-948 Owner’s Manual Page 4-29
To Next Page
Loading...
Need help?
General
