ADDITIONAL TR FUNCTIONS
Storing setups
Setups can be stored at any time using the STORE soft key.This saves the current desk setup to the current title on the
S
D memory card.
Setups can be renamed from the AWS Remote – see page 6-11
New setups are numbered starting at ‘1’. If a setup is deleted (see below) then its number will not be re-used.The only
exception to this is if all setups are deleted.The numbering will then restart from ‘1’.
Deleting Setups
Setups can be deleted from memory by highlighting the setup up you wish to delete, holding down the DELETE soft key
and pressing the CONFIRM soft key.
Restoring Legacy MIDI Setups from a Mac or PC
For legacy purposes, it is possible to load setups which have been saved via a MIDI SysEx dump.The AWS uses MIDI port 4,
or ipMIDI port 8, for loading mixes.
• Locate the DAW to just before the SysEx data containing the setups you wish to load.
• Press the Load soft key.
• Play through the SysEx block of data.As soon as theAWS detects the start of valid data it will delete all the current setups
and replace them with the stored ones from the MIDI track.
• The restored Setups can now be saved as part of a console Project using the AWS Remote - see Section 5 for more
details.
Because the Load process replaces your current setups with the ones stored on your Mac or PC you should check
you have saved any setups you wish to keep before loading new ones.
Note that when importing older AWS projects,TR elements which cannot be matched will prevent Auto Scan from
working properly.
Total Recall
AWS 924-948 Owner’s Manual Page 6-9
To Next Page
Loading...
Need help?
General
