AWS 924-948 Operator’s Manual Page 7-17
Automation
PRO TOOLS SETUP NOTES
To enable timecode generation, click on the GEN MTC button in the transport window:
Now open the Synchronisation tab in the Setup/Peripherals window and select the port on the MIDI interface that is
connected to AWS Port 4 MIDI IN or IP MIDI Port 7. Also select the timecode rate for the session and the session start
time. It is expedient to make a note of the timecode standard that was used for a particular AWS mixing project. Automation
automatically detects the timecode standard from the incoming MTC messages. It will quite happily attempt to play out
stored mix data to incoming timecode with a different frame rate, but this will result in small but potentially annoying timing
errors in automation playback.
To Next Page
Loading...
