The majority of DAW functions are controlled via dedicated AWS front panel switches – less reliance is placed on the 8x8
soft key matrix located beneath the TFT screen than with the HUI protocol.
All Plug-In editing is via the channel V-pots. The four encoders together with the six switches below the centre section
monitor screen are not used with the Mackie Control protocol.
On the channel fader strips, the Auto key and associated status LEDs are also not implemented by the protocol. All other
controls, the V-pot and associated encoder switch, DAW channel Solo and Cut plus the Select and Ready functions, are
fully supported.
O
nly mono metering information is returned from the workstation. On stereo channels the maximum value of the left or
right channel is displayed. The master fader is also included in the DAW layer when a Mackie Control template is active.
The ten keys located above master transport keys provide different related motion control functions according to the
active template. When required tallies for these keys will be displayed on the TFT display in the area next to the DAW
timeline counter.
The Jog Wheel together with the Scrub function key, and the Cursor keys and Cursor mode switch are active in all templates.
The outer Jog Wheel is not supported, neither is the numeric keypad. However the 1-8 keys replicate F1 - F8 Function keys
in certain templates.
DAW Control
Page 4-32 AWS 924-948 Owner’s Manual
To Next Page
Loading...
Need help?
General
