Sony DVS-9000SF - Page 109

109DME Special Effect Operations
Chapter 11 DME Operations
To invert the lighted area
Press [Light Invert], turning it on.
The lighted area is inverted.
To add color to the light source
Use the following procedure.
1 In the Light 1 menu, press [Light Color Adjust].
The Light Color Adjust menu appears.
2 In the <Fill Blending Mode> group, select how the light and image should
be blended.
Mix: Light as if reflected from a mirror.
Multiply: Light as if reflected from a dull surface (diffuse reflection).
3 If you selected Mix, select the fill color in the <Fill Source> group.
Flat Color: A monochrome matte.
Hue Rotation: Color matte with a color that gradually varies.
4 According to the selection, set the following parameters.
• When you selected Flat Color
a) 100.00: The image beneath the light shines through.
• When you selected Hue Rotation
a) –12.00 is a 360-degree rotation every second in the counterclockwise direction. +12.00 is
a 360-degree rotation every second in the clockwise direction.
b) 100.00: The image beneath the light shines through.
Knob Parameter Adjustment Setting values
1 Luminance Luminance 0.00 to 100.00
2 Saturation Saturation 0.00 to 100.00
3 Hue Hue 359.99 to 0.00
4 Brilliancy Brilliance of surface struck by light
0.00 to 100.00
a)
Knob Parameter Adjustment Setting values
1 Luminance Luminance 0.00 to 100.00
2 Saturation Saturation 0.00 to 100.00
3 Speed Speed at which hue changes
–12.00 to +12.00
a)
4 Brilliancy Brilliance of surface struck by light
0.00 to 100.00
b)