Sony DVS-9000SF - Page 108

Chapter 11 DME Operations
108
DME Special Effect Operations
The display on knob 5 that was visible when [Shape] was selected changes.
2 Set the following parameter.
a) –100.00 is four rotations per second in the counterclockwise direction, and +100.00 is four
rotations per second in the clockwise direction. 0.00 stops the rotation.
To change the light to a ring shape
Use the following procedure.
Note
If you select Parallel or Whole (see page 105) in the <Spot Mode> group and
shaping is disabled, the Ring parameter cannot be set.
1 Press [Ring] and set the following parameters.
a) –1.00 is one rotation in the counterclockwise direction and +1.00 is one rotation in the
clockwise direction.
Note
There is no Radius setting when Line is selected in the <Spot Mode>
group.
To rotate the ring
Use the following procedure.
1 Press [Ring Speed], turning it on.
The display on knob 3 that was visible when [Ring] was selected changes.
2 Set the following parameter.
a) –100.00 is four rotations per second in the counterclockwise direction, and +100.00 is four
rotations per second in the clockwise direction. 0.00 stops the rotation.
Knob Parameter Adjustment Setting values
5 Speed Rotation direction and speed
–100.00 to +100.00
a)
Knob Parameter Adjustment Setting values
1 Offset Offset from center position
(radius)
–6.00 to +6.00
2 Radius Radius of ring 0.00 to 6.00
3 Angle Rotation angle of ring
–8.00 to +8.00
a)
Knob Parameter Adjustment Setting values
3 Speed Rotation speed and direction.
–100.00 to +100.00
a)