249Setup Relating to Operations From the Control Panel
Chapter 16 Engineering Setup
• When the operating bank order is changed, the state of region selection
button assignment in the numeric keypad control block also changes
correspondingly.
3
For the selected Bank number, in the <M/E Operation> group, select one
of the following.
Enable: Enable panel display and operation of the operating bank.
Disable: Enable only panel display, and disable operation of the operating
bank.
Inhibit: Disable both the panel display and operation of the operating
bank.
Note
When this is set to Inhibit, snapshots of the operating bank are not recalled.
Assigning two M/E banks to one M/E bank
Use the following procedure.
1
In the Panel>Config menu, select the M/E bank for which you want to
make the setting.
• Press directly on the list in the status area.
• Press the arrow keys to scroll the reverse video cursor.
• Turn the knob.
For example, if the furthest bank from you is assigned to M/E-1, and you
want no shift button operation for the bank, select 1 for Bank.
2
Press [Dual M/E Assign].
This assigns the furthest M/E bank from you to the unshifted cross-points
and the M/E bank in front of it to the shifted cross-points. For fader lever
operations, only the M/E bank closer to you is enabled.
To return to the original assignment
Interchange the operating bank order (see page 248).
Knob Parameter Adjustment Setting values
1 Bank Selection of position of operating bank for
which you want to make the setting
1 to 4
To Next Page
Loading...
