Chapter 16 Engineering Setup
250
Setup Relating to Operations From the Control Panel
Assigning the key delegation in the downstream key control
block
As an example, to assign key 4 of the M/E-1 bank to key delegation button 1
of the downstream key control block 1, use the following procedure.
1
In the Panel>Config menu, press the [DSK Fader Assign].
The DSK Fader Assign menu appears.
2
Directly press on the indications in the status area, to select the
downstream key control block for which you want to make the setting, and
select the key delegation.
Here, press on the intersection of the “1st Module” column and “Key1
Assign” row.
3
In the <M/E Select> group, select the operating bank of the key you want
to assign.
Here, select [M/E-1] as an example.
4
In the <Key Link Select> group, select the key you want to assign.
Here, select [Key4] as an example.
5
To disable the fader lever of the selected downstream key control block,
select [Disable] in the <Fader Assign> group.
To enable the fader lever, select one of the following in the <Fader
Assign> group, determine the key to which the fader lever operation
applies.
All: Key selected with one of the key delegation buttons
Key1: Key assigned to key delegation button 1 ([DSK1] button)
Key2: Key assigned to key delegation button 2 ([DSK2] button)
Key3: Key assigned to key delegation button 3 ([DSK3] button)
Key4: Key assigned to key delegation button 4 ([DSK4] button)
Linking switcher bus and router destination
To provide links between the switcher bus and router destination, make the
following settings as required.
Matrix selection: Select the target of link setting from the eight matrices (1 to
8).
Matrix position definition: Set the start address and level for the source and
destination on the S-Bus.
Link table setting: Link a switcher cross-point button and matrix source.
Link bus setting: Link a switcher bus address and router destination.
To Next Page
Loading...
