275Setup Relating to Operations From the Control Panel
Chapter 16 Engineering Setup
3
In the utility/shotbox control block, select the bank, and press the button to
which you want to assign the shortcut.
The menu screen goes back to the Prefs/Utility>Utility Module Assign
menu, and the selection is reflected in the status area.
The buttons in the utility/shotbox control block stop flashing, and the
button to which the menu shortcut is assigned lights orange.
To abandon the process of menu shortcut assignment
In the Prefs/Utility>Utility Module Assign menu, press [Menu Shortcut].
This exits the menu shortcut assignment mode.
Setting names to be displayed in memory recall buttons
Note
The name you set using the following procedure is displayed only when “Menu
Shortcut” or “Utility Command” has been assigned to the selected memory
recall button. To set a name for display in a memory recall button to which
“Shotbox Recall” has been assigned, use the Shotbox menu.
Use the following procedure.
1
In the Prefs/Utility>Utility Module Assign menu, select the button using
any of the following methods.
• Press directly on the list.
• Press the arrow keys to scroll the reverse video cursor.
• Turn the knobs.
2
Press [Name].
A keyboard window appears.
3
Enter a name of not more than eight characters, and press [Enter].
The name you have set is reflected in the status area and on the memory
recall button in the utility/shotbox control block.
Knob Parameter Adjustment Setting values
1 Bank Bank selection 1 to 4
2 Button No Control block button selection 1 to 24
To Next Page
Loading...
