285Setup Relating to Operations From the Control Panel
Chapter 16 Engineering Setup
2
Make the following settings as required.
Operation mode of the [ALL] button in the transition control block:
To specify the next transition to be selected by pressing the [ALL]
button in the transition control block, press the next transition you
want to select, turning it on, in the <Next Trans All> group. If
everything here is set to Off, then pressing the [ALL] button does not
change the specification of the next transition.
Operation mode during an auto transition: For the operation mode
when the [AUTO TRANS] or [TAKE] button is pressed once more
during an auto transition, select [Continue] or [Cancel] in the <Auto
Trans/Take> group.
Continue: Continue the auto transition.
Cancel: Cancel the auto transition and return to the state before
starting the auto transition.
Operation mode during keyframe execution: For the operation mode
when the [RUN] button is pressed once more during effect execution,
select [Continue] or [Cancel] in the <RUN> group.
Continue: Continue the execution.
Cancel: Cancel the execution and return to the state before starting the
execution.
Interchanging the [AUTO TRANS] and [CUT] buttons: To
interchange the [AUTO TRANS] and [CUT] buttons in the transition
control block, press the [Auto Trans/Cut Swap] button, turning it on.
Transition preview operation mode: For the operation mode of the
[TRANS PVW] button, select [Lock] or [Hold] in the <Trans Pvw>
group. The setting as to whether to use the “One-time mode” in which
the transition preview terminates when the transition completes, or to
use button control, is made on the switcher side (see page 299).
CCP-9000-specific button settings: Press [CCP-9000 Button], and skip
to step 3.
3
If required, make the following settings.
DME channel selection mode: To set the mode when one of the [DME1]
to [DME4] buttons in the key delegation section is pressed to select the
DME channel, select either of the following in the <DME Select>
group.
Override: Forcibly select the selected channel. (Later selection takes
precedence)
Pre Select: It is not possible to select a channel that has already been
otherwise selected. (Earlier selection takes precedence)
Operating mode of the [XPT HOLD] button in the key delegation
section: To set the operating mode of the [XPT HOLD] button in the
key delegation section, select either of the following in the <Xpt
Hold> group.
To Next Page
Loading...
